Table of Contents
Advertisement
Installation
3.2
Quick Setup
Table 3-1 gives a quick overview of the Q-750d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
Install CineWide lens mounting assembly (stationary base
2
plate or AutoScope lens motor – optional)
3
Mount the projector
Connect the DHD Controller to the projector
4
Connect signal sources to the DHD Controller
5
Connect external controller to RS-232 port (optional)
6
Connect 12-volt trigger outputs to AutoScope lens motor
7
and/or other equipment (optional)
Connect projector, DHD Controller and lens motor (if
8
present) to AC power and power up
Primary lens adjustments: projected image size (zoom),
9
position (shift) and focus
For rear-screen and/or ceiling-mount installations, select
10
the proper picture orientation
Install CineWide anamorphic lens (optional)
11
CineWide lens adjustments: position, pitch (angle),
12
geometry and focus
Display calibration: adjust the following for each input and
display mode (resolution and frame rate); save settings
when finished:
• Aspect ratio
• Brightness
13
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
Procedure
14
Q-750d Series Installation/Operation Manual
For Details, Refer to
page...
15
21
28
29
31
36
37
39
18, 40
40
41
41
49
Advertisement
Table of Contents
