Assembling / Disassembly Of The Attachments; Cleaning Instructions - Hendi 222140 User Manual

7. ASSEMBLING / DISASSEMBLY OF THE ATTACHMENTS

The assembly / disassembly operations of the appliance are performed with the appliance stopped and dis-
connected from the power supply.
Assembly: Model 222140:
1. Align and insert the coupling (5) of the blending
shaft (3) or the whisk (6) in the clutch (2) of the
main unit (1).
2. Screw thoroughly the blending arm (3) or whisk
(6) to the main unit (1).
Assembly: Model 222171 and 222188:
1. Align and insert the coupling (5) of the blending
shaft (3) or the whisk (4) in the clutch (2) of the
EN
main unit (1). Make sure the narrower part of the
appliance coupling fi ts the concave side of the
blender shaft (3) or whisk (4) arm coupling.
2. Screw the nut (6) up to fasten it fi rmly to the main
unit (1).
Follow the above steps in the reverse order to disassembly the accessories.

8. CLEANING INSTRUCTIONS

Before cleaning always unplug the appliance form
the source of power supply.
• After using the Stick Blender in a hot mixture,
cool the blending shaft in cold water before dis-
mantling the bell from the blender shaft. Clean
the shaft immediately after use to prevent adhe-
sion of the mixture.
• Never immerse the motor unit or the handle in
water; clean with a damp cloth or a sponge.
• Blender shaft and bell cleaning: Place the blend-
8
4
1
3
2
1
3
2
ing arm and the bell in a suitable container with
clean water and switch on for a few seconds.
• WARNING: Always dry the blades thoroughly af-
ter cleaning to avoid rust spotting.
• Never immerse the whisk holder in water; clean
with a damp cloth or a sponge.
• After use clean the appliance with a detergent or
disinfectant. Do not use undiluted bleach. Do not
use alkaline detergents to clean plastic parts.
5
5
6
5 5
6
4