Calibration - Runco PLASMAWALL XP-50DHD Installation And Operation Manual

Use the Calibration menu to perform advanced picture quality adjustments. This menu
should be used by ISF-certified technicians only.
You must enter a passcode to access the Calibration menu.
Note
To recall the ISF Night or ISF Day settings, select "ISF Night" or "ISF Day" from the
Memory Presets menu (see page 47) or use the corresponding remote control buttons.
Display Color: Use the Display Color settings to adjust the color balance at the DHD
Controller output. These settings are saved independently for each input and display
mode.
• Gain: Use the Gain controls to correct color imbalances in the bright areas of the
image. A good way to do this is to use a test pattern consisting mostly of solid white
areas, such as an 80 IRE "window" pattern. If the white areas contain traces of red (Pr),
green (Y) or blue (Pr), decrease the Gain for that color.
• Offset: Use the Offset controls to correct color imbalances in the dark areas of the
image. A good way to do this is to use a test pattern consisting mostly of dark gray
areas, such as a 30 IRE "window" pattern. If the gray areas contain traces of red (Pr),
green (Y) or blue (Pr), decrease the Offset for that color.
• Gamma: Select Gamma from the Display Color menu to choose a de-gamma curve.
Used correctly, the Gamma control can improve contrast while maintaining good
details for blacks and whites. If excess ambient light washes out the image and it
becomes difficult or impossible to see details in dark areas, lower the gamma setting to
compensate. This improves contrast while maintaining good details for blacks.
Conversely, if the image is washed out and unnatural, with excessive detail in black
areas, increase the setting.
Select S-Curve to emphasize mid-level (gray area) detail, relative to the black and
white areas of the image.
PlasmaWall XP Series Installation/Operation Manual 49
Operation

Calibration

Calibration
ISF Settings
Display Color
Input Image
Input Color
Save ISF Night
Save ISF Day
Copy/Paste
Output Shift
Splash Configure
OSD Position