Runco PLASMAWALL XP-50DHD Installation And Operation Manual page 30

Controls and Functions
10. Aspect Ratio Selection Buttons
Use the red buttons to select an aspect ratio directly or to enter numeric characters,
as follows:
16:9 (3)
For viewing 16:9 DVDs or HDTV programs in their native aspect ratio.
4:3 (6)
Scales the input signal to fit 4:3 display mode in the center of the screen.
LETBOX (Letterbox) (9)
For viewing LaserDisc movies or non-anamorphic DVDs on a 16:9 screen.
V-WIDE (VirtualWide)
Enlarges a 4:3 image horizontally in a NON-linear fashion to fit 16:9 full screen display.
CINEMA
For viewing 2.35:1 source material. The upper and lower portions are masked.
SVC
Selects the Virtual Cinema aspect ratio.
11. S-VID 1 (4) / S-VID 2 (5) (S-Video)
Press to select an S-Video input or to enter the numeric character "4" or "5."
12. HD 1 (7) / HD 2 (8)
Press to select a HD (RGBHV or YPbPr component) input or to enter the numeric
character "7" or "8."
13. HDMI 1 / HDMI 2 (0)
Press to select a Digital Video input. Press HDMI 2 to enter the numeric character
"0."
14. Memory Preset Buttons:
ISF NIGHT
Press to recall settings for the current input from the "ISF Night" memory preset.
ISF DAY
Press to recall settings for the current input from the "ISF Day" memory preset.
CUST 1
Press to recall settings for the current input from the "Custom 1" memory preset.
THX (XP-65DHD and XP-OPAL65DHD) / CUST 2 (XP-50DHD, XP-OPAL50DHD
and XP-103DHD)
Press to recall settings for the current input from the "THX" or "Custom 2" memory
preset.
14 PlasmaWall XP Series Installation/Operation Manual