Product-Dependent Symbols; Symbols On The Product; Highlighting Of Designations And Markings; Product Information - Hilti GX-IE Manual

Wireless data transfer
1.3

Product-dependent symbols

1.3.1

Symbols on the product

The following symbols are used on the product:
General mandatory sign
Wear eye protection
Wear ear protection
Wear a hard hat
Return waste material for recycling
1.3.2

Highlighting of designations and markings

Designations and markings are indicated as follows:
‚ ‛ Description of marked operating controls on the fastening tool
« » Markings on the fastening tool
1.4

Product information

Hilti products are designed for professional users and only trained, authorized personnel are permitted to
operate, service and maintain the products. This personnel must be specifically informed about the possible
hazards. The product and its ancillary equipment can present hazards if used incorrectly by untrained
personnel or if used not in accordance with the intended use.
▶ In the table below, enter the designation and serial number from the type identification plate.
▶ Always quote this information when you contact a Hilti representative or Hilti Service to make an inquiry
about the product.
Product information
Fastening tool, gas-actuated
Generation:
Serial number:
1.5

Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
2

Safety

2.1

Safety instructions

These safety instructions apply for fastening tools with and without magazine.
Working safely with the fastening tool
▶ Pressing the nosepiece of the fastening tool against a part of the body may lead to serious injury due to
inadvertent actuation and release of a fastener. Never press the nosepiece of the tool against your
hand or any other part of the body.
▶ When inserting/loading application-specific fasteners (e.g. washers, clips or clamps, etc.) in/on the
fastener guide there is a risk of serious injury due to inadvertent actuation of the tool resulting in
Printed: 07.05.2018 | Doc-Nr: PUB / 5426517 / 000 / 00
GX-IE
GX-IE XL
01
English 3