Tape Operation; General Operation; Line Out Connection - Jensen JTA-990 User Manual

GENERAL OPERATION

1. Press the "TAPE" button to select "TAPE" mode.
2. The system will start playback automatically after inserting the
cassette tape.
3. Adjust the volume to the desired level.
4. Press the TAPE FAST FORWARD / EJECT button half way when
playing, the tape will be advanced forward rapidly.
5. Slightly press the TAPE FAST FORWARD / EJECT button again to
resume normal playback. The button will resume to the outermost
position.
6. Press the TAPE FAST FORWARD / EJECT button completely, then the playing will be
stopped and the cassette tape will be ejected.
Notes:
- Make sure the direction is correct when inserting the tape.
- Some searching noise can be heard and the system cannot perform normal playback
function during fast forward mode.
- To avoid damaging the tape, it is recommended to take the cassette tape out of the deck
after listening.

LINE OUT CONNECTION

You can connect this unit to an external Hi-Fi / AMPLIFIER system by connecting the
LINE OUT socket to the auxiliary input socket of your Hi-Fi / AMPLIFIER system with
RCA cables (not included).
Note: The Volume control on the main unit will not adjust the volume when using the LINE OUT.
3.5MM STEREO HEADPHONE JACK
The stereo headphone jack is located on the right front panel. Plug a set of stereo headphones
(not included) into this jack for private listening without disturbing others. The speakers are
automatically disconnected when headphones are connected to the jack.
Read this Important Information before Using Your Headphones
1.) Avoid extended play at very high volume as it may impair your hearing.
2.) If you experience ringing in your ears, reduce the volume or shut off the unit.
3.) Keep the volume at a reasonable level even if your headset is an open-air type
designed to allow you to hear outside sounds. Please note that excessively high
volume may still block outside sounds.

TAPE OPERATION

E24