Adjusting The Seat Height - KTM 50 SX 2017 Owner's Manual

10 TUNING THE CHASSIS
1 0 0 1
2 0 0 2
10.17

Adjusting the seat height

Warning
Danger of accidents Modifications to the suspension settings can seriously alter the vehicle's ride behavior.
–
Following modifications, ride slowly at first to get the feel of the new ride behavior.
–
Remove the screws
lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the screws
–
Place the handlebar support in the required position. Fit and tighten the

screws
400564-10
Guideline
Screw, handlebar support
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Fit and evenly tighten the screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap width is even.
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Remove nut
V00264-10
–
Hold the rear wheel with the swingarm and remove screw
–
Position the shock absorber according to the required seat height.
Guideline
Low seat position (standard)
High seat position
–
Position screw
V00265-10

. Take off the handlebar clamps. Remove the handlebar and
 . Remove the handlebar support.
.
M10

.

.
Loctite
40 Nm
(29.5 lbf ft)

.
M8 20 Nm
(14.8 lbf ft)
p. 34)

.


32
® 243™