KTM 50 SX 2017 Owner's Manual page 68

12 BRAKE SYSTEM
–
Insert the new brake linings.
Info
Always change the brake linings in pairs.
Ensure that the brake linings are correctly positioned in the holding spring.
–
Position the brake caliper on the brake disc.
The brake linings are correctly positioned.
–
Attach the brake line to holder
H01450-10
–
Mount and tighten screws
Guideline
Rear brake caliper screw
–
Mount screw
Guideline
Screw, brake linings
–
Mount lock washer
S00880-10
–
Check the brake discs. (
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
–
Add brake fluid up to level
Guideline
Level 
voir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position the membrane and the cover with the washer. Mount and tighten the
H01187-10
screws.
Info
Clean up overflowed or spilled brake fluid immediately with water.
Finishing work
–
Remove the motorcycle from the lift stand. (

.

.
M6

.

.
p. 57)

.
(brake fluid level below reser-
p. 93)
Loctite
10 Nm
(7.4 lbf ft)
M5 8 Nm (5.9 lbf ft)
10 mm (0.39 in)
p. 34)
66
® 243™