Projector Warm Up; Warm Up On/Off - Runco DTV-1200 Owner's Manual

Projector Warm Up

What can be done?
When in the ON position (and the CRT run in cycle is OFF), the projector can start up with a warm up period.
The warm up time can be set up by the customer as well as the frequency of the warm up source. During the
start up a warm up menu will be displayed. This menu offers the option to skip the warm up period by pressing
the EXIT key and offers the possibility to adjust the horizontal and vertical amplitude of this white image with the
cursor keys. During this warm up period, a full white image is shifted on the CRT faceplate to avoid a burn in.
Every 30 seconds a text box will be displayed on another place on the screen with the remaining time to go.
When EXIT is pressed during this warm up period, the warm up menu will be redisplayed with the remaining
time indication. Press another time EXIT to interrupt the warm up cycle. When the warm up option is OFF, when
switching on the projector, it starts immediately with the projection of the selected source.
How to select?
1. Push the cursor key
2. Press ENTER to select. The projector warm up menu will be displayed (menu 2).
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
Select with or
then <ENTER>
<EXIT> to return

Warm Up On/Off

What can be done?
The warm up option can be toggled between ON and OFF.
When in the ON position, while starting up the projector, the warm up cycle will be executed.
When in the OFF position, the projector starts up with inmediate image projection.
How to turn on the Warm up mode?
1. Push the cursor key
2. Press ENTER to toggle between ON and OFF.
or to highlight 'Projector Warm up' (menu 1).
menu 1
or to highlight 'Warm up' (menu 1).
PROJECTOR WARM UP
WARM UP : ON
FREQUENCY : 64 kHz
TIME : 15 min
A FULL WHITE PATTERN
WILL BE GENERATED AT
POWER UP
AFTER THIS PROCEDURE
THE PROJECTOR IS READY
TO PERFORM IN OPTIMUM
CONDITION
with <ENTER>
<EXIT> to return
PROJECTOR WARM UP
WARM UP :
FREQUENCY : 64 kHz
A FULL WHITE PATTERN
WILL BE GENERATED AT
AFTER THIS PROCEDURE
THE PROJECTOR IS READY
TO PERFORM IN OPTIMUM
with <ENTER>
<EXIT> to return
58
menu 2
ON
TIME : 15 min
POWER UP
CONDITION
menu 1