Remote Commands To The Projector - Runco DTV-1200 Owner's Manual

Remote Commands to the Projector

Pointing the Remote to the reflective screen
Point the front of the Remote to the screen surface.
Ceiling
Screen
Point the front of the Remote towards one of the IR sensors in the projector.
Front of projector
45° 45°
F2 F3 F4
F1 F5
ADJ EXIT
ENTER
PAUSE TEXT
PHASE
9 0
SHARPN
7 8
TINT
5 6
COLOR
3 4
BRIGHTN
1 2
CONTR
TREBLE BALANCE
BASS VOL
When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft
in a straight line). The remote control unit will not function properly if strong light strikes the sensor window or if
there are obstacles between the remote control unit and the projector's IR sensor.
Remote used in a hardwired configuration.
RS232 INRS232 OUT IR REMOTE
IN RS232 OUT RS232 IR REMOTE
IR sensor
Remote
Rear side of projector
See installation instructions before connecting to the supply.
Voir la notice d'installation avant de raccorder au réseau. " This devicecomplies with Part 15 of
the FCC Rules. Operationis subject to
following two conditions: (1) This
device may not cause harmful inter-
V-nom 800 peripherals R G B Comp-/H-Sync V-Sync S-VIDEO OFF - ON VIDEO OFF - ON green : operation ference, and (2) this device must
I-nom 120/230 V 75 Ohm 75 Ohm red : standby accept any interference received,
OFF ON Freq 7/5 Amp 50/60 Hz including interferencethat may cause
POWER / MAINS COMM. PORT PORT 3 PORT 4/5 PORT 2 PORT 1 PROJECTOR MODE undesired operation"
45° 45°
F3
F2 F4
F1 F5
ADJ EXIT
ENTER
PAUSE TEXT
Remote
PHASE
9 0
SHARPN
7 8
TINT
6
5 COLOR
3 4 BRIGHTN
1 2 CONTR
TREBLE BALANCE
BASS VOL
Plug one end of the remote cable in the
connector on the bottom of the Remote and
the second side in the connector in the rear
panel of the projector labelled 'REMOTE'.
17