Runco DTV-1200 Owner's Manual page 8

3. Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the
cord. To disconnect the cord, pull it out by the plug. Never pull the cord itself.
4. If an extension cord is used with this product, make sure that the total of the ampere ratings on the products
plugged into the extension cord does not exceed the extension cord ampere rating.
5. Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage-
points or short out parts that could result in a risk of fire or electrical shock.
Never spill liquid of any kind on the product. Should any liquid or solid object fall into the cabinet, unplug the set
and have it checked by qualified service personnel before resuming operations.
6. Lightning - For added protection for this video product during a lightning storm, or when it is left unattended
and unused for long periods of time, unplug it from the wall outlet. This will prevent damage to the projector due
to lightning and AC power-line surges.
Caution on Fire Hazard
Do not place flammable or combustible materials near projector !
Runco large screen projection products are designed and manufactured to meet the most stringent safety regu-
lations. This projector radiates heat on its external surfaces and from ventilation ducts during normal operation,
which is both normal and safe.
Exploding, flammable or combustible materials into close proximity of this projector could result in the sponta-
neous ignition of that material, resulting in a fire. For this reason, it is absolutely necessary to leave an "exclu-
sion zone" around all external surfaces of the projector whereby no flammable or combustible materials are
present. Do not cover the projector with any material while the projector is in operation.
Keep flammable and combustible materials away from the projector at all times. Mount the projector is a well
ventilated area away from sources of ignition and out of direct sun light. Never expose the projector to rain or
excessive moisture. In the event of fire, use sand, CO2, or dry powder fire extinguishers; never use water on an
electrical fire.
Always have service performed on this projector by authorized Runco service personnel. Always insist on gen-
uine Runco replacement parts. Never use non-Runco replacement parts as they may degrade the safety of this
projector.
On Installation
1. Do not place this equipment on an unstable cart, stand, or table. The product may fall, causing serious
damage to it.
2. Do not use this equipment near water.
3. Slots and openings in the cabinet and the back or bottom are provided for ventilation; to ensure reliable oper-
ation of the product and to protect it from overheating, these openings must not be blocked or covered. The
openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This
product should never be placed near or over a radiator or heat register.
The projector should not be placed in a built-in installation or enclosure unless proper ventilation is provided.
4. Do not block the projector cooling fans or free air movement under and around the projector. Loose papers or
other objects may not be nearer to the projector than 4" on any side.
6