Installing The Tiller Hitch And Pulleys; Installing The Rear Shield; Installing The Lift Cable And Lift Lever - Toro 79370 Operator's Manual

Installing the Tiller Hitch and
Pulleys
1. Tip tiller onto back and support in an upright position.
Remove the 3/8 x 5-1/2 inch bolt and the
3/8 x 4-1/2 inch bolt from the tiller gear case (Fig. 2).
Discard extra nuts used as spacers for shipping.
2. Fasten hitch and spring bracket to gear case with the
bolt (3/8 x 5–1/2 inch) and nut (3/8 inch) shown in
Figure 2.
Note: Make sure the 3/8 x 4–1/2 inch bolt is install as
shown in Figure 2.
3. Install the bolt (3/8 x 4–1/2 inch) through the hitch and
gear case shown in Figure 2. Do not install the nut
(3/8 inch) at this tme.
4. Install the drive pulley, so the hub is a 1/4 inch from the
end of the drive shaft (Fig. 2). Secure pulley with a
square key and 2 square head set screws (5/16 inch).
Important
Key must be located under a set screw to be
retained.
5. Align the belt cover with the hitch. Install the belt cover
onto the 3/8 x 4–1/2 inch bolt and fasten the bolt with a
nut (3/8 inch).
6. Assemble idler pulley and belt guide into lower hole of
belt guard and install onto hitch through upper hole
with a bolt (3/8 x 1–5/8 inch) and a lock nut (3/8 inch)
(Fig. 2).
11 8
1
13
2
4
12
Figure 2
1. Hitch
2. Spring bracket
3. Bolt, 3/8 x 5–1/2 inch
4. Nut, 3/8 inch
5. Drive pulley
6. Key
7. Set screw, 5/16 inch
10
9
4
14
6
5
7
3
m–6313
8. Idler pulley
9. Belt cover
10. Bolt, 3/8 x 1–5/8 inch
11. Lock nut, 3/8 inch
12. Tiller gear case
13. Bolt, 3/8 x 4–1/2 inch
14. Upper hole

Installing the Rear Shield

1. Rotate tiller down and hook rear shield into slots at rear
of tine shield. Secure with 3 cotter pins (1 inch) (Fig. 3).
1
2
Figure 3
1. Rear shield
2. Cotter pin, 1 inch
2. Attach lift chain, short link end and one link short, to
lift bracket. Secure lift chain with clevis, clevis pin and
a cotter pin (3/4 inch) (Fig. 4).
6
5
Figure 4
1. Short link end
2. Clevis
3. Clevis pin
Installing the Lift Cable and Lift
Lever
1. Remove the carriage bolts at fender mount under the
seat and attaching footrests (Fig. 5).
Note: Save all hardware for use when installing fenders.
2. Unplug seat wiring harness connector and remove wire
harness from wire clip.
Note: If tractor has a 25 amp fuse clipped inside console,
remove the fuse.
7
3
1282
3. Slot
2
1
3
4
2294
4. Bracket
5. Cotter pin, 3/4 inch
6. Lift chain