Installing The Drawbar Hitch Pin - Toro 73470 Setup Instructions

Set-Up Instructions
4. When the battery is fully charged, unplug the
charger from electrical outlet, then disconnect
the charger leads from the battery posts (Fig. 4).
4
2
Figure 4
1. Positive battery post
2. Negative battery post
5. Slowly pour electrolyte into each cell until the
level is once again up to "UPPER" line on the
battery case (Fig. 3), then install the filler caps.
6. Install the battery in the tractor and connect the
battery cables (refer to Installing the Battery in
your tractor Operator's Manual).
Note: Do not run the tractor with the battery
disconnected.
6
3
1
1254
3. Red (+) charger lead
4. Black (–) charger lead
Installing the Drawbar Hitch
Pin
Insert the drawbar hitch pin into the drawbar hitch
and secure it with a .50" I.D. flat washer and hairpin
cotter (Fig. 5).
2
4
Figure 5
1. Drawbar hitch pin
2. Drawbar hitch
1
3
m–2481
3. .50" Flat washer
4. Hairpin cotter