Toro 79370 Operator's Manual page 8

3. Remove the fender\seat pan from the tractor.
2
2
Figure 5
1. Fender\seat pan
4. Remove bolts and lock washers securing fuel tank
bracket to the top of transmission (Fig. 6).
5. Select proper cable tube; straight for gear drive and bent
for hydrostatic drive. Secure the cable tube, fuel tank
bracket and clamp with previously removed lock
washers and bolts (Fig. 6 and 7).
2
1
Figure 6
1. Cable tube—gear drive
2. Cable tube—hydrostatic
drive
2
1
2
1229a
2. Carriage bolt
5
3
4
2293
3. Clamp
4. Bracket
5. Bolt
Top View
1
6
Figure 7
1. Cable tube—gear drive
2. Clamp
3. Bracket
6. Slide a shim washer and bushing onto both ends of lift
lever rod (Fig. 8).
Important Check that bushings slide easily onto rod
ends and into frame. Remove paint if necessary.
7. Position lift lever into frame and slide bushings and
shim washers outward into frame holes. Secure in
position with E-rings (Fig. 8).
Important
Lift lever must not have excessive end play
(more than 0.015 inch). Use extra shim washers (0.015 and
0.020 inch thick) to reduce end play.
2
1
Figure 8
1. Bushing
2. Shim Washer (as
required)
Note: If the tractor has a 25 amp fuse clipped inside
console, install the fuse.
8. Slide ball end of attachment lift cable through cable
tube from the rear of machine.
8
4
5
2
3
m–5670
4. Gear shift
5. Fuel line
6. Cable
5
3
4
2291
3. Lift lever
4. Frame hole
5. E-ring