Storage - Toro 79370 Operator's Manual

6. Pull on idler arm spring to relieve tension and route belt
around tiller drive pulley, under tiller idler and inside
belt guide (Fig. 32).
7. Check that belt is properly routed around all pulleys and
belt guide (Fig. 32).
Important
Belt must be properly routed behind belt
guide to prevent jumping off and premature failure.
3
4
Figure 32
1. Inner groove of (PTO)
power take off, clutch
2. Mid-mount idler pulleys
8. Install belt guard to mid-mount bracket with 2 self
tapping bolts (1/4 x 1/2 inch) (Fig. 33).
4
1 2
3
Figure 33
1. Belt guard
2. Idler bracket
1
2 2313
3. Tiller pulley
4. Tiller idler
2312
3. Bolt, 1/4 x 1/2 inch
4. Belt guide
18

Storage

1. Before long term storage wash the machine with mild
detergent and water to remove dirt and grime from the
entire machine.
2. Check the condition of the drive belt.
3. Check gearcase lubrication level; refer to Greasing and
Lubrication, page 16.
4. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
5. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
6. Store the machine in a clean, dry garage or storage area.
Cover the machine to protect it and keep it clean.