Removing The Drawbar; Assembling The Mounting Plate; Installing The Mounting Plate - Toro 79370 Operator's Manual

9. Select correct clevis as follows:
2 inch long clevis: for 8-speed gear drive and
hydrostatic models with oil filter on right side.
3-1/8 inch long clevis: for hydrostatic models with
oil filter facing rear.
10. Lower attachment lift and place cable, ball end, into slot
in clevis (Fig. 9). Attach clevis to hole in attachment lift
and secure with clevis pin and a cotter pin (1 inch)
(Fig. 9).
3
2
5
Figure 9
1. Lift cable knob
2. Clevis (select proper size)
3. Attachment lift
11. Thread trunnion 1 inch (26 mm) onto the treaded end of
lift cable. Insert trunion into lower hole of lift lever.
Secure with a washer (3/8 inch) and hairpin cotter
(Fig. 10).
1
2
Figure 10
1. Trunnion
2. Lift cable threaded end
3. Lower hole in lift lever
12. Install fenders and seat with previously removed
hardware.
13. Plug the wiring harness connector into the seat and
insert wire harness into wire clip.
1
4 2315
4. Clevis pin
5. Cotter pin, 1 inch
4
5
3
2309
4. Washer, 3/8 inch
5. Hairpin cotter

Removing the Drawbar

1. Remove snap ring from pin and slide from drawbar and
spacers. Remove hitch from tractor (Fig. 11).
Note: Save all hardware for use when re-installing hitch.
Figure 11
1. Snap ring
2. Pin

Assembling the Mounting Plate

1. Install latch levers to mounting plate with carriage bolts
(3/8 x 1 inch), washers (3/8 inch) and lock nuts
(3/8 inch) (Fig. 12).
Note: Tighten nuts so latch levers move, but hold in
position for ease of tiller mounting to tractor.
5
1
Figure 12
1. Mounting plate
2. Carriage bolt, 3/8 x 1 inch
3. Washer, 3/8 inch

Installing the Mounting Plate

1. Center hitch on axle housing and install with 4 carriage
bolts (3/8 x 3 inch), left side angle plate (with hole
rearward), right side strap and lock nut (3/8 inch) as
shown in figure 13.
Note: For hydrostatic models with oil filter facing rear,
locate hitch 3-1/4 inch (8.3 cm) from right side of center
housing.
9
1
3
2
2314
3. Drawbar
4. Spacer
3
2
4
2308
4. Latch lever
5. Lock tut, 3/8 inch