Installing Your Coolbot Pro; Connecting Your Coolbot Pro To Your Wi-Fi Network - Store It Cold CoolBot PRO Instruction Manual

Hide thumbs Also See for CoolBot PRO:

Construction manual (72 pages)

Manual (4 pages)

Quick start setup manual (4 pages)

Table Of Contents

Table of Contents

Watch our CoolBot Pro Installation Video at

CONNECTING YOUR COOLBOT PRO TO YOUR WI-FI NETWORK

A subscription plan is required in order to access and use the CoolBot Pro App

CoolBot Pro and CoolBot Jumper Set Up

STEP 1

Unpack the CoolBot Pro in an area with good Wi-Fi reception (outside of your cooler). Plug in the

Temperature Sensors and the Heater Cable into the corresponding ports (See diagram on page 4). Don't

connect the cables to your A/C and don't plug in the power supply.

STEP 2

Connect the CoolBot Jumper to the CoolBot Pro using ONLY the provided silver/grey Data Cable. The

provided Data Cable is specific to the CoolBot Pro/Jumper – standard phone cable will not work and may

damage your CoolBot Pro/Jumper.

STEP 3

In an area where your phone gets good Wi-Fi reception, plug in the CoolBot Pro's Power Supply. You should

see codes and flashing mode lights for several seconds. These should settle down to one flashing Program

light, and the code "E0" alternating with the current room temperature.

Wi-Fi Configuration and Web App Set Up

STEP 4

Start the CoolBot Pro App by scanning the QR Code on your smartphone or go to the

web page

https://cb.storeitcold.com

PC, etc.).

STEP 5

On the first screen, fill in your email address and create a password. The email address

will be used for notifications, as well as to link your data to your account.

STEP 6

Select "Create New Account" and the App will guide you through configuring the CoolBot Pro to talk to the

CoolBot server using your Wi-Fi Network.

STEP 7

The App will also connect you to our credit card processing portal for selection and payment for the

subscription service of your choice. This is necessary to enable the CoolBot Pro's interactive App-based

features.

STEP 8

Continue to follow the prompts. When prompted, you will need to change the Wi-Fi settings on your device

(smartphone, tablet, PC) to connect to the Wi-Fi Network called "CoolBot". On most smartphone use

Settings > Wi-Fi and on most PCs use the network or Wi-Fi status icon.

STEP 9

Choose or type in the Wi-Fi Network you want the CoolBot to use. This is usually the same network your

phone uses, but it can be a different network if you prefer. Enter the Wi-Fi password for the network and

press Next.

STEP 10

Once the CoolBot Pro is connected to the Network, you should see no codes (and no flashing) on the

CoolBot Pro display.

Rev: 2018 – 7A