Er Is Showing On My Coolbot Display; Ef Flashes On My Coolbot Display - Store It Cold CoolBot PRO Instruction Manual

Er IS SHOWING ON MY COOLBOT DISPLAY

Er is a communication error with the Room Sensor.
● Unplug the Room Sensor from the CoolBot Pro.
● Inspect the cable for possible damages in the cord or on the tip.
● Clean the plug end of the sensor (jack connector) with a cotton cloth and plug it back in the CoolBot Pro port
a couple times making sure it goes all the way in.
● If the error persists after 20 seconds, unplug the sensor from the Room port and switch ports with the FINS
sensor by plugging the ROOM sensor in the Fins port and the FINS sensor in the Room port.
● If the "Er" message is gone and now you have a flashing "Ef" while the Fins Mode light blinks rapidly, then
your ROOM sensor cable (currently plugged in the Fins port) is bad and needs replacement.
● Plug the FINS sensor back into the Fins port.
● Discard your ROOM Sensor.
● "Er" will still show on the display (because there is nothing plugged in the Room port). That is all right.
The CoolBot Pro can work with 1 good sensor (plugged in to the Fins port) in a "Safety Mode" while your
replacement sensor is being shipped. DO NOT plug anything in the ROOM port!
Since the CoolBot won't display the room temperature while running in the "Safety Mode," the Room temperature
will have to be monitored with the aid of an external thermometer.
To order a replacement sensor under warranty (1 year) please contact our support team at support@storeitcold.com.
To purchase new sensors please visit our parts page at:

Ef FLASHES ON MY COOLBOT DISPLAY

The Fins Mode Indicator light flashes rapidly.
Ef is a communication error with the FINS sensor.
● Unplug the FINS sensor from the CoolBot.
● Inspect the cable for possible damages in the cord or on the tip.
● Clean the plug end (jack connector) of the sensor with a cotton cloth and plug it back in the CoolBot port a
couple times making sure it goes all the way in.
● If the error persists after 20 seconds, the sensor is bad and needs replacement.
● Unplug the FINS sensor and discard.
● Unplug your ROOM sensor and plug into the Fins port.
● You will see an "Er" message on the screen (because there is nothing plugged in the Room port). That is all
right.
● If the "Ef" message stopped flashing and the Fins mode indicator light stopped flashing rapidly you are now
working in the "Safety Mode".
● Insert the tip of the sensor into the fins of the A/C (center bottom) following the same recommendations as
in the installation guide (STEP 7- Page 11).
The CoolBot Pro can work with 1 good sensor (plugged in to the Fins port) in a "Safety Mode" while your
replacement sensor is being shipped. DO NOT plug anything in the ROOM port!
Since the CoolBot won't display the room temperature while running in the "Safety Mode," the Room temperature
will have to be monitored with the aid of an external thermometer.
To order a replacement sensor under warranty (1 year) please contact our support team at support@storeitcold.com.
To purchase new sensors please visit our parts page at:
Rev: 2018 – 7A
- SAFETY MODE-
https://www.storeitcold.com/replacement-parts/
- SAFETY MODE-
https://www.storeitcold.com/replacement-parts/
©2018 Store It Cold, LLC 22