Proper Installation And Settings; Double Your Warranty - Store It Cold CoolBot PRO Instruction Manual

PROPER INSTALLATION AND SETTINGS

•
Make sure your A/C is on "COOL" Mode and the Fan on "HIGH"
•
Make sure your A/C is a compatible brand. Check compatibility at:
•
Make sure that the A/C is draining properly.
The back of the A/C should be a lower (about 1 inch) than the front (inside) and the unit should be level from
side to side, so condensation can drain out the back. This is very important!
•
Check the insulation around your A/C opening. This is a critical point in your Cooler for condensation.
•
Make sure your A/C unit does NOT have a Secondary Sensor.
If the cooler is stuck around 45-50⁰F/7-10⁰C, or if the compressor comes off and does not cycle ON back for
a while, or if it cools down and then waits a long time to start cooling again, look for a Secondary Sensor on
your A/C (See INSTALLING YOUR COOLBOT STEP 6, page 10).
NOTE: This can happen even if your A/C has been installed for some time and was working correctly before
– please ensure your A/C does not have a secondary sensor if you are experiencing these problems (See
INSTALLING YOUR COOLBOT STEP 6, page 10).
Visit our support page at
We'd love to hear how your CoolBot is doing and learn more about how you are using it. Just fill out our Testimonials
Form online, and as a way to say "Thanks!", we will double your CoolBot Pro warranty from 1 to 2 years!
You can find the Testimonials Form at:
FOLLOW US:
https://www.storeitcold.com
https://www.facebook.com/thecoolbot
https://www.instagram.com/storeitcold
https://twitter.com/storeitcold
https://www.youtube.com/storeitcold
Rev: 2018 – 7A
FOR TROUBLESHOOTING AND QUESTIONS
https://www.storeitcold.com/support
Or contact us at support@storeitcold.com

DOUBLE YOUR WARRANTY!

https://www.storeitcold.com/welcome/
©2018 Store It Cold, LLC
https://www.storeitcold.com/support
25