Table of Contents
Advertisement
Preparing the Machine for Use
Attach the air hose to the regulator.
WARNING
To source
of com-
pressed air
To attach: Insert firmly as far as it
will go.
Supply compressed air and verify that air does not leak from the connections or any
other location.
WARNING
Loosen
(Increase the
pressure.)
32
Securely insert the air hose as far as it will go. Lightly
tug the hose to make sure it does not come loose.
If it is not inserted securely, it may come loose.
To detach: Press and hold the ring,
and pull out.
Turn the air pressure adjustment knob slowly and carefully.
Otherwise, the machine may move suddenly, posing a risk of
injury.
Adjust the air pressure.
Upper knob
(air pressure ad-
air pressure.
justment knob)
For the recommended set pressure for each work-
piece, see "Preparing Compressed Air (Setting the
Regulator)" in "Preparing for Milling" in the "User's
Tighten
Manual (electronic-format manual)."
(Decrease
the pressure.)
Be sure to configure the regulator to 0.2 MPa
or lower. Anything higher may result in a
malfunction.
Included air hose
Pull up on the upper knob.
Slowly turn the upper knob to adjust the
Push down on the upper knob.
Advertisement
Table of Contents
