Important Notes on Handling and Use
This machine is a precision device. To ensure the full performance of this machine, be sure to ob-
serve the following important points. Failure to observe these points may not only result in loss of
performance but may also cause malfunction or breakdown.
This machine is a precision device.
Handle carefully, and never subject the machine to impacts or excessive force.
Carefully clean away milling waste.
Use within the range of specifications.
Never attempt to move the spindle unit or rotary axis unit by hand with undue force.
Never needlessly touch anywhere inside the machine except for locations specified in this manual.
Install in a suitable location.
Install in a location that meets the specified conditions for temperature, relative humidity, and the like.
Install in a quiet, stable location offering good operating conditions.
Never install outside.
Never install in an environment where silicone substances (oil, grease, spray, etc.) are present. Doing so
may cause poor switch contact or ionizer damage.
This machine becomes hot.
Never cover the ventilation holes with cloth or anything else.
Install in a well-ventilated location.
This machine is a dedicated cutting machine for Zirconia, Wax, PMMA, PEEK, and Composite resin.
Never cut any material other than Zirconia, Wax, PMMA, PEEK, and Composite resin.
About the milling bur
The tip of the milling bur is breakable. Handle with care, being careful not to drop the bur.
19