Signal Spotting; Scanning A Terrestrial Antenna In Rf Mode - Triax MCT059 User Manual

Attention : To exit a window like in this example below, press the key:
2.2

Signal spotting

The MCT059 appliance tracks very quickly RF or optical terrestrial or satellite signals.
In the following chapter, we will see how to spot a RF signal on three types of installation:
Checking of a terrestrial antenna (the installation has already been made).
•
Installation of a terrestrial antenna.
•
Installation of a satellite dish.
•
2.2.1

Scanning a terrestrial antenna in RF mode

In this case, the Autoset function allows a scan of the channels that the antenna detects.
Plug the cable of your antenna to the MCT059 appliance (WARNING: use an adequate adaptor)
The antenna shall be previously adjusted to a terrestrial emitter.
Turn on your appliance. Press RF/Optic
Press Entrée RF
The Home page appears on screen. Press Autoset
On this page, press Mode, Terrestrial, then select DVB-T and 8MHz (as here below)
The scan should range from the E21 to the E69 channels, frequency range Europe (you may reduce the
number of channels to scan if you know the range of the emitter where the antenna points at: the scan will
be faster)
– MCT059 –
p.
11