Fit Stem - Bike Friday Pocket Rocket Manual

Accessories: Fit Stem
Fit Stem (Optional)
If your bike was designed to receive a Custom Ultra-light Stem, then
most likely the bike you just received has a Fit Stem installed. The
Fit Stem process is designed to ensure the highest level of accuracy
and satisfaction in producing a truly custom fit for your new bike.
The Fit Stem is a temporary, but fully usable stem which can be
adjusted to any height and projection. Ride with the Fit Stem as
you would normally ride and tour. Either take a wrench with you,
or use your 5/6mm S-wrench in the bottle cage, and stop to adjust
your fit as necessary. We encourage you to put 125 miles or more on
the stem, until you are satisfied with the overall fit of your bike.
When you have finished the fitting process, remove the stem and
send it back to us in the supplied FedEx box along with the infor-
mation card. The only essential details are your name, address and
bike color. Once you have the stem boxed up and the card filled out,
call FedEx at 800-463-3339 to arrange a pick up. It normally takes
about two weeks to complete your new Custom Ultra-light Stem.
If you need a quicker turnaround for a trip or event, let us know
on the card or call us to arrange for expedited service. We have
completed stems in as short as two working days. (There is a fee for
this service.)
Horizontal Adjustment
(Leave Tight)
Fit Stem Adjustment
Set the stem projection by loosen-
ing the two bolts at the top of the
stem and moving the bars horizon-
tally. Set the stem height by loosen-
ing the single bolt at the top of the
lower stem sleeve and moving the
Vertical
bars vertically.
Adjustment
(Leave Tight)
Returning Fit Stem
When you are ready to send the
stem back to us (or to pack the bike),
leave the two adjusting clamps
Stem Clamp
tight. Only remove the handlebars
(Remove
and loosen the lowest stem collar.
Here)
45
800-777-0258 • +1-541-687-0487 www.bikefriday.com