Fenders; Fit Stem - Bike Friday Family Tandem Traveler User Manual

Accessories: Fenders
1. Front Fender
Your front fender has an
alignment pin (a small bolt)
through the aluminum tab
beneath the mounting hole.
The fender is a�ached to the
fork by the upper hole, while
the alignment pin keeps the
fender from rotating.
2. Rear Fender
Your rear fender has one
hole in the aluminum tab,
and the fender extends far-
ther forward of the tab than
the front fender. The fender
is a�ached to the rear end by
the bolt in the wish bone.
56
www.bikefriday.com
Mounting
Bolt
Alignment
Pin
Fig. 1 Front fender.
Fig. 2 Rear fender.
800-777-0258 • +1-541-687-0487
Accessories: Fit Stem
Fit Stem (Optional)
If your bike was designed to receive a Custom Ultra-light Stem,
then most likely the bike you just received has a Fit Stem installed.
The Fit Stem process is designed to ensure the highest level of
accuracy and satisfaction in producing a truly custom fit for your
new bike.
The Fit Stem is a temporary, but fully usable stem which can be
adjusted to any height and projection. Ride with the Fit Stem as
you would normally ride and tour. Either take a wrench with you,
or use your 5/6mm S-wrench in the bo�le cage, and stop to adjust
your fit as necessary. We encourage you to put 125 miles or more on
the stem, until you are satisfied with the overall fit of your bike.
When you have finished the fi�ing process, remove the stem and
send it back to us in the supplied FedEx box along with the infor-
mation card. The only essential details are your name, address and
bike color. Once you have the stem boxed up and the card filled out,
call FedEx at 800-463-3339 to arrange a pick up. It normally takes
about two weeks to complete your new Custom Ultra-light Stem.
If you need a quicker turnaround for a trip or event, let us know
on the card or call us to arrange for expedited service. We have
completed stems in as short as two
working days. (There is a fee for
this service.)
Fit Stem Adjustment
Set the stem projection by loosen-
ing the two bolts at the top of the
stem and moving the bars horizon-
tally. Set the stem height by loosen-
ing the single bolt at the top of the
lower stem sleeve and moving the
bars vertically.
Returning Fit Stem
When you are ready to send the
stem back to us (or to pack the
bike), leave the two adjusting
clamps tight. Only remove the
handlebars and loosen the lowest
stem collar.
800-777-0258 • +1-541-687-0487
Horizontal Adjustment
(Leave Tight)
Vertical
Adjustment
(Leave Tight)
Stem Clamp
(Remove
Here)
Fig. 1 Removing fit stem.
57
www.bikefriday.com