Close Codesys Project And Save Configuration - JUMO mTRON T 570 Operating Manual

3 Configuration
3.2.9

Close CODESYS project and save configuration

Step
1
2
3
4
5
32
Activity
Close project
➥ The PLC application is transferred to the setup program again.
Setup program: Follow the note to end CODESYS, and close with "OK"
The operating panel's CODESYS project planning (PLC application) is not trans-
ferred to the system and thus is not saved on the CPU, in contrast with the system's
PLC application (see Step 5). The setup file must therefore be saved in the setup
program so that the operating panel's PLC application is also available for later mod-
ifications (see Step 6).
Setup program: Follow the note to end CODESYS, and close with "OK"
In the setup program, exit the "project settings" dialog with "OK"
Setup program: transfer the project to the system (device)