Mitsubishi Q2ASCPU User Manual page 81

Error
Code Error Contents and Cause
(SD0)
Runaway or failure of CPU module or
failure of main CPU
1000 • Malfunctioning due to noise or other
reason
• Hardware fault
Entire program was executed without
the execution of an END instruction.
• When the END instruction is
executed it is read as another
1010
instruction code, e.g. due to noise.
• The END instruction has been
changed to another instruction code
somehow.
Corrective Action
• Take noise reduction measures.
• Reset the CPU module and RUN it
again.If the same error is displayed
again, this suggests a CPU module
hardware fault.(Contact your local
Mitsubishi representative.)
• Take noise reduction measures.
• Reset the CPU module and RUN it
again. If the same error is displayed
again, this suggests a CPU module
hardware fault. (Contact your local
Mitsubishi representative.)
66
Corresponding
CPU
QnA
QnA