Error
Code
Error Contents and Cause
(SD0)
The parameter setting is illegal.
• Though Block 0 was set to "Automatic
3200
start" in the SFC setting of the PLC
parameter dialog box, Block 0 does
not exist.
3201
The block parameter setting is illegal.
The number of step relays specified in
the device setting of the PLC parameter
3202
dialog box is less than that used in the
program.
The execution type of the SFC program
specified in the program setting of the
3203
PLC parameter dialog box is other than
scan execution.
Corrective Action
Read the common information of the
error using the peripheral device, check
error step corresponding to its
numerical value (program error
location), and correct the problem.
98
Corresponding
CPU
QnA
QnA
QnA
QnA