Mitsubishi Q2ASCPU User Manual page 103

Error
Code Error Contents and Cause
(SD0)
• The specified program does not exist
in the program memory.
This error may occur when the
2410 ECALL, EFCALL, PSTOP, PSCAN,
POFF or PLOW instruction is
executed.
• The specified file does not exist.
• The file is the one which cannot be
specified by the sequence program
(such as comment file).
• The specified program exists in the
program memory, but has not been
2411
registered in the program setting of
the Parameter dialog box.
This error may occur when the
ECALL, EFCALL, PSTOP, PSCAN or
POFF instruction is executed.
The SFC program file is one that cannot
2412 be designated by the sequence
program.
No data has been written to the file
2413
designated by the sequence program.
Corrective Action
• Read the individual information of the
error using the peripheral device,
check to be sure that the program
corresponds to the numerical values
there (program location), and correct.
Create a file created using
parameters, and load it to the CPU
module.
• In case a specified file does not exist,
write the file to a target memory and/
or check the file specified with the
instruction again.
Read the individual information of the
error using the peripheral device, check
to be sure that the program
corresponds to the numerical values
there (program location), and correct.
Read the individual information of the
error using the peripheral device, check
to be sure that the program
corresponds to the numerical values
there (program location), and correct.
Read the individual information of the
error using the peripheral device, check
to be sure that the program
corresponds to the numerical values
there (program location), and correct.
Check to ensure that the designated file
has not been write protected.
88
Corresponding
CPU
QnA
QnA
QnA
QnA