Scan Tuning - Sony ICF-SW1005 Operating Lnstructions

Scan Tuning
1
Set MAIN POWER ON/OFF to ON.
2
Press POWER ON/OFF.
--4,5
.-7
---5,6
3
Receive a broadcast band by way of direct tuning or manual
tuning. (Refer to the table on page 23 for the frequency range of
each broadcast band.)
4
Keep pressing one
of
outer buttons
of
JOG/MANUAL
TUNE/SCAN for about 2 seconds. "SCAN" will appear in the
label display and scan tuning will begin within the frequency range
of the table on page 23. When a station is received, the scanning
will stop automatically for about 2 seconds and the tuning indicator
appears in the display.
5
Press one
of
JOG/MANUAL TUNE/SCAN again to listen to the
station being received. The scan tuning stops and the station being
received is tuned in. .
6
Tune in the station more precisely by inner buttons of
JOG/MANUAL TUNE/SCAN.
7
Adjust VOL(volume).
To tum off the radio, press POWER ON/OFF.
The frequency allocation (channel
step)
LW:3kHz
MW: 9 kHz/10 kHz
SW:5kHz
FM:50kHz
When scan tuning stops
too often
Set
SENS to LOCAL.