Using The Wide Range Antenna - Sony ICF-SW1005 Operating Lnstructions

Using the Wide Range Antenna (not supplied)
Use the wide range antenna AN-1 or AN-102 (not supplied).
There are following two methods.
Method A (For SW reception)
With a connecting
cord~
connect the OUTPUT jack of the antenna
controller (supplied with the AN-1 or AN-102) and the ACTIVE ANT
jack of the ICF-SW100.
Method B (For MW /LW reception only)
1
With the connecting cord, connect the OUTPUT jack of the antenna
controller and the INPUT jack of the antenna coupler (supplied with
the AN-1 or AN-102).
2
Put the antenna coupler near the ICF-SW100.
Example: When the AN-1 is used .
....._~~cc:::tr:=J:Jo•.._
__________ _.
Notes
•When receiving
MW
or
LW
broadcasts
without the active antenna, be sure to
disconnect a SW external antenna.
Otherwise, you cannot receive them as
the
built-in ferrite bar antenna does not
function.
•If there is lightning, do not touch the
wire of an external antenna and
disconnect its AC power adaptor
(if
connected) immediately. Never touch
the
antenna wire during a lightning
storm.
to
ACTIVE ANT
(SW)
•When using an external antenna, retract
the telescopic antenna.
•Locate the outdoor antenna as far away
from the street as possible.
•For
details about the external antenna,
refer
to
its instruction manual.
•