Chapter 1 Setup; Checking For Shipping Damages And Accessories; Precautions For Installation - Kikusui TOS8870A Operation Manuals

Chapter 1
This chapter describes unpacking and general preliminary notes and precautions.
1.1 Checking for Shipping Damages and
Accessories
■ Unpacking
The Tester should be checking upon receipt for damage that might have occurred during transporta-
tion. Also check that all accessories have been provided.
Should the Tester be damaged or accessory missing, notify your Kikusui agent/distributor.
Packing
■
•
CAUTION
注意
•

1.2 Precautions for Installation

Be sure to observe the following precautions when installing the unit.
■ Do not use the unit in a flammable atmosphere.
To prevent explosion or fire, do not use the unit near alcohol or thinner, or in an atmosphere con-
taining such vapors.
■
Avoid locations where the unit is exposed to high temperature or direct
sunshine.
Do not locate the unit near a heater or in areas subject to drastic temperature changes.
Operation temperature range: 0 ˚C to 40 ˚C
Storage temperature range: -20 ˚C to 70 ˚C
■ Avoid locations of high humidity.
Do not locate the unit in high-humidity locations, i.e., near a boiler, humidifier, water supply, etc.
Operation humidity range: 20 % to 80 % RH (without condensation)
Storage humidity range: 80 % RH or less (without condensation)
Dew condensation may take place even in the operation humidity range. In such a case, do not use
the unit until the dew dries up completely.
SETUP
2
Item
Power cord
TL01-TOS High Voltage Test Leadwires
(Approx.1.5m)
"DANGER High-Voltage" sticker
Operation Manual
When transporting the Tester, be sure to use the original packing materials. If they
are missing, contact your Kikusui agent/distributor.
When packing the Tester, remove the power cord and all other connection cables.
SETUP
Accessories
Parts No.
85-AA-0003
KA-0607-02
A8-210-202
Z1-002-472
Q'ty Check
1
1
1
1
TOS8870A