Lenovo THINKPAD X1 Tablet Gen 3 Hardware Maintenance Manual page 52

Table 4. System board connector and cable guide
Item
Connector (location)
1
Rear-facing camera module
connector (internal)
2
P-sensor connector (internal)
3
Wireless-WAN card slot (internal)
4
NFC card connector (internal)
4
Infrared camera module connector
(internal)
5
Front-facing camera module
connector (internal)
6
Power board connector (internal)
7
Wireless-LAN antenna connector
(internal)
8
Thermal fan connector (internal)
9
Coin-cell battery connector
(internal)
10
Fingerprint-reader connector
(internal)
11
Volume control board connector
(internal)
12
LCD and touch controller card
connector (internal)
13
POGO card connector (internal)
14
Built-in battery connector (internal)
15
M.2 solid-state drive slot (internal)
46
X1 Tablet Gen 3 Hardware Maintenance Manual
Internal cable required
Rear-facing camera module cable
P-sensor cable
No
NFC-card cable
Infrared camera module cable
Front-facing camera module cable
Power board cable
Wireless-LAN antenna assembly
Thermal fan cable
Coin-cell battery cable
Fingerprint-reader cable
Volume control board cable
LCD and touch controller card
cable
POGO-card cable
Built-in battery cable
No
Cable connection
The rear-facing camera module
comes with a cable. Connect the
cable to this connector.
The wireless-WAN antenna
assembly comes with cables.
Connect the P-sensor cable to this
connector.
Insert the wireless-WAN card into
this slot.
Connect one end to the NFC card
and the other end to this
connector.
Connect one end to the infrared
camera module and the other end
to this connector.
Connect one end to the front-
facing camera module and the
other end to this connector.
The power board comes with a
cable. Connect the cable to this
connector.
Stick one end of the wireless-LAN
antenna assembly to the back
cover assembly and the other end
to this connector.
The thermal fan comes with a
cable. Connect the cable to this
connector.
The coin-cell battery comes with a
cable. Connect the cable to this
connector.
The fingerprint-reader comes with
a cable. Connect the cable to this
connector.
Connect one end to the volume
control board and the other end to
this connector.
Connect the Y end to the LCD
panel and touch controller card;
connect the other end to this
connector.
The POGO card comes with a
cable. Connect the cable to this
connector.
The built-in battery comes with a
cable. Connect the cable to this
connector.
Insert the M.2 solid-state drive into
this slot.