Rhythm Gate Indicator Flipped; Dynamic Gate Low Limit; Dynamic Gate High Limit - Yamaha DTX402K Owner's Manual

Advanced Techniques
4.
Select the setting for each drum pad using the number
buttons [1] to [5]. When set to producing a sound, the
pad will produce a sound whenever they are struck.
When set not to producing a sound, only pads played
exactly in time will produce a sound.
Number button
[1] Hi-Hat
[2] Snare
[3] Kick
[4] Tom
[5] Cymbal

6-4. Rhythm Gate Indicator Flipped

Steps:
Hold down the Mode switch  [6]  [4]  Setting
For Rhythm Gate (page 32), the time indicator using the
number buttons can be reversed, according to your prefer-
ence. In the normal mode, "fast" is on the left. In the reverse
mode, "fast" is on the right.
1.
Hold down the Mode switch to activate Menu Mode.
2.
Press the number button [6] to select the Training Set-
tings.
3.
Press the number button [4] to select Rhythm Gate
Indicator Flipped.
4.
Select the mode using the number button [1] or [2].
Number
Settings
button
Normal
[1]
mode
Reverse
[2]
mode
52
DTX402K DTX432K DTX452K Owner's Manual
Setting Parameters using Menu Mode
Settings
Produce a sound (fully lit)
Not producing a sound (half lit)
Setting
Description
Fast Slow
1 2 3 4 5 6 7 8 9 10
Slow Fast
1 2 3 4 5 6 7 8 9 10

6-5. Dynamic Gate Low Limit

Steps:
Hold down the Mode switch  [6]  [5]  Setting
For Dynamic Gate (page 33), you can set the low limit (the
threshold value between "Weak" and "Normal").
1.
Hold down the Mode switch to activate Menu Mode.
2.
Press the number button [6] to select the Training Set-
tings.
3.
Press the number button [5] to select Dynamic Gate
Low Limit.
4.
Set the threshold value using the TEMPO[+]/[–] but-
tons.
Setting
2 to 99
NOTE
This setting may be automatically fixed so as not to exceed the
setting value of Dynamic Gate High Limit.

6-6. Dynamic Gate High Limit

Steps:
Hold down the Mode switch  [6]  [6]  Setting
For Dynamic Gate (page 33), you can set the high limit (the
threshold value between "Normal" and "Strong").
1.
Hold down the Mode switch to activate Menu Mode.
2.
Press the number button [6] to select the Training Set-
tings.
3.
Press the number button [6] to select Dynamic Gate
High Limit.
4.
Set the threshold value using the TEMPO[+]/[–] but-
tons.
Setting
2 to 99
NOTE
This setting may be automatically fixed so as not to be below the
setting value of Dynamic Gate Low Limit.
Setting
Setting