Yamaha DTX402K Owner's Manual page 22

Setup
Assembly Guide
Step 14
Connecting the pads to the drum module
TOM2 TOM1
RIDE
TOM3
DTX402K
1.
Insert the mini plugs* at one end of the nine-channel snake cable into the correct trigger input jacks (SNARE to KICK/
PAD) on the drum module. (*: The smaller set of plugs.)
NOTE
The sticker on each of the snake cable's plugs indicates the name of the corresponding pad.
2.
Insert the nine-channel snake cable's standard plugs* into the jacks in the corresponding pads. (*: The larger set of plugs.)
NOTE
For the kick pad KP65 in the DTX432K and DTX452K, use the OUT>DTX jack. No sound will be played when the PAD>IN jack is
used.
3.
Wrap the cables for the snare pads, the tom pads, and the cymbal/hi-hat pads around the cable clips to prevent them from
being pulled out.
NOTICE
Excessive bending can damage the cables. Ensure, therefore, that they are not bent at an extreme angle when wrapped around the
clips.
4.
Using the cable bands, secure the cables to the kit rack at the
Congratulations—You have finished assembling your electronic drum kit!
Here is a left-handed setup.
Fully assembled drum kit (DTX452K shown)
20
DTX402K DTX432K DTX452K Owner's Manual
CR
HH
SNR
KICK
HHC
KICK HHC
Trigger input jacks on the drum module
SNR TOM1 TOM2 TOM3
CR TOM1 TOM2
Nine-channel snake cable
positions in the figure above.
Please assemble the drum kit referring to the image.
NOTE
Please ensure that the two joints in the figure below are used in different ways
from how they are used in the right-handed setup.
Right-handed • • • • • • • • • • • • • • • • Left-handed • • • • • • • • • • • • • • • • • •
RIDE CR HH
HH SNR RIDE TOM3 KICK
HHC KICK
HHC