ABB REM615 ANSI 5.0 FP1 Product Manual page 37

—
Table 57. Circuit breaker failure protection (CCBRBRF) main settings
Parameter
Current value
Current value Res
CB failure mode
CB fail trip mode
Retrip time
CB failure delay
CB fault delay
—
Table 58. Arc protection (ARCSARC)
Characteristic
Operation accuracy
Operation mode = "Light
Start time
+current"(1), (2)
Operation mode = "Light
only"(2)
Reset time
Reset ratio
1 Not included in REM615
2 Set Operate delay time = 0.06 s,Operate curve type = IEC definite time, Measurement mode = default (depends on stage), current before fault = 0.0 × In, fn = 50 Hz, earth-fault current
with nominal frequency injected from random phase angle, results based on statistical distribution of 1000 measurements
3 Includes the delay of the signal output contact
4) Maximum Start value = 2.5 × In, Start value multiples in range of 1.5...20
—
Table 59. Arc protection (ARCSARC) main settings
Parameter
Phase start value
Ground start value
Operation mode
—
Table 60. Multipurpose protection (MAPGAPC)
Characteristc
Operation accuracy
—
Table 61. Multipurpose protection (MAPGAPC) main settings
Parameter
Start value
Operate delay time
Operation mode
Function
CCBRBRF
CCBRBRF
CCBRBRF
CCBRBRF
CCBRBRF
CCBRBRF
CCBRBRF
Value
±3% of the set value or ±0.01 × I
Minimum
9 ms(3)
4 ms(4)
9 ms(3)
4 ms(4)
Typically 40 ms
Typically 0.96
Function
ARCSARC
ARCSARC
ARCSARC
Function
MAPGAPC
MAPGAPC
MAPGAPC
Value (range)
0.05...2.00 × I
n
0.05...2.00 × I
n
1 = Current
2 = Breaker status
3 = Both
1 = Off
2 = Without check
3 = Current check
0...60000 ms
0...60000 ms
0...60000 ms
n
Typical
12 ms(3)
6 ms(4)
10 ms(3)
6 ms(4)
Value (range)
0.50...40.00 × In
0.05...8.00 × In
1 = Light+current
2 = Light only
3 = BI controlled
Value
±1.0% of the set value or ±20 ms
Value (range)
-10000.0...10000.0
0...200000 ms
1 = Over
2 = Under
Step
0.05
0.05
—
—
10
10
10
Maximum
15 ms(3)
9 ms(4)
12 ms(3)
7 ms(4)
Step
0.01
0.01
—
Step
0.1
100
—
37