ALDI GERM32 User Manual page 28

GB IRE
Maintenance
reduced and the cutting device should be replaced.
3. Keep the cutting device sharp to ensure a good cutting
performance. Replace a worn or damaged cutting device with
a new one of the same type.
Replacing the blades
Always unplug the lawn mower before removing or refitting the
blades.
1. Loosen the bolt, turning anticlockwise using a suitable
wrench and remove it together with the cutting device (See
Fig P).
2. Replace the cutting device with a new one of the same type.
3. Reattach the cutting device onto the spindle, pay attention
to correct alignment. Tighten the bolt clockwise with 16
Nm min, 20 Nm max. to ensure the safe operation of your
product.
4. Replace this cutting device after 50 hours mowing or 2 years
whichever is sooner regardless of condition. If the cutting
device is cracked or damaged, immediately replace it with a
new one.
5. Lubricate the cutting device after each use to prolong the life
span of the cutting device and product. Apply light machine
oil along the edge of the cutting device.
AFTER SALES SUPPORT
+44 (0)1904 727501
GB
+353 (0)1 902 2605
IRE
1000W Lawn Mower
www.coreservice.co.uk
28