Important Safety Information - Danfoss DP200 User Manual

User Manual
W

Important Safety Information

y Disconnect your machine's battery power before connecting power and signal cables to
the DP2xx.
y Before doing any electrical welding on your machine, disconnect all power and signal
cable cables connected to the DP2xx.
y Do not exceed the DP2xx power supply voltage ratings. Using higher voltages may
damage the DP2xx and can create a fire or electrical shock hazard.
y Do not use or store the DP2xx where flammable gases or chemicals are present.
y Using or storing the DP2xx where flammable gases or chemicals are present may cause an
explosion.
y Software configures the keypad buttons on the DP2xx. Do not use these buttons to
implement critical safety features. Use separate mechanical switches to implement critical
safety features such as emergency stops.
y Design systems that use the DP2xx so that a communication error or failure between the
DP2xx and other units cannot cause a malfunction that might injure people or damage
material.
y The protective glass over the DP2xx display screen will break if hit with a hard or heavy
object. Install the DP2xx to reduce the possibility of it being hit by hard or heavy objects.
y If you break the protective glass of the DP2xx screen, remove the DP2xx and immediately
return it to Danfoss for service.
y Storing or operating a DP2xx in an environment that exceeds the DP2xx specified
temperature or humidity rating may damage the DP2xx.
y Always clean the DP2xx with a soft, damp cloth. Use a mild dishwashing detergent as
needed.
y The DP2xx is not user serviceable. Return the DP2xx to the factory in case of failure.
EIC-Engine Information Center – DP2xx
11032748_Rev DA_Sep2014
47