Selecting J1939 Monitor Signals - Danfoss DP200 User Manual

User Manual
Setup Options

Selecting J1939 Monitor Signals

EIC-Engine Information Center – DP2xx
3. After screen type selection, select
signals to monitor. Use the up and down
arrow soft keys to cycle through
available signal selections.
4. After making a signal selection, press
the right arrow (Next) soft key to go to
the next selection area. Use the up,
down arrow, next and select soft keys to
select signal. Select the right arrow soft
key to move to the next selection area.
11032748_Rev DA_Sep2014
29