Beale Street Audio P4-MB Installation Manual page 7

Installation
P4-MB
Connections
• Strip the insulation on each conductor approximately 1/2" (12.7mm) and
insert to the speaker terminals. Ensure that there are no stray strands
of wire protruding from the connectors that can cause shorts. Observe
proper polarity (+ to + and – to – for each speaker and at the amplifier)
and that surround channels are properly positioned and connected, if
used.
Installation
• With the 'dogs' flush to the side of the speaker, insert the speaker into
the cutout and tighten each of the four screws to swing the dogs out,
and clamp the speaker to the drywall. Do not overtighten.
Turn screws to extend dogs
as shown
16AWG (min)
Stranded Speaker Wire
+ to +
- to -
Amplifier Speaker Terminal
16AWG (min)
Stranded Speaker Wire
+ to +
- to -
L- L+ R- R+
7
Turn screws to extend dogs
as shown