Wall Mounting The Rhi Panel - Trane IntelliPak SCWF 20 Installation, Operation And Maintenance Manual

I I n n s s t t a a l l l l a a t t i i o o n n - - E E l l e e c c t t r r i i c c a a l l
1. Mount an electrical junction box in the wall so that
the front edge of the box will be flush with the
finished wall surface.
2. Prior to mounting the panel, the microprocessor
module must be carefully removed from the
enclosure. To remove the module:
a. Lay the remote panel face up on a flat surface
and remove the locking screw from the right
hand bottom end of the panel.
b. Remove the recessed hinge screw from the left
hand bottom end of the panel.
c. Unlatch the door of the enclosure as if to open
it, and slide the left hand side of the door
upward away from the hinge. Lay it aside.
d. With the key pad visible, remove the two screws
located on the right hand side of the key pad.
e. Carefully slide the key pad plate upward from
the bottom, releasing the extruded hinge pin
from its socket at the top.
f. Set the microprocessor aside until mounting is
complete.
3. Remove the junction box knockout in the back of
the enclosure.
N N o o t t e e : : The top of the enclosure is marked "TOP."
4. With the enclosure in the correct position; align the
mounting holes around the knockout in the
enclosure with the screw holes in the electrical
handy box and secure with the appropriate screws.
5. Replace the microprocessor within the enclosure as
follows:
a. Verify that the terminal block jumpers are
connected properly.
b. Slide the extruded hinge pin at the top left of the
key pad plate into the hole located at the top left
hand side of the enclosure.
c. Slide the bottom of the plate into place, aligning
52
the two clearance holes with the screw holes on
the right. Install the screws but do not tighten.
N N o o t t e e : : If the two screws are not installed as
called out in the previous step, hold
against the key pad plate while installing
the door in the next step, to prevent it
from falling out.
d. Slide the extruded hinge pin at the top left of the
door into the hole located under the bottom left
side of the display.
e. Install and tighten the hinge screw located at the
bottom left side of the enclosure.

Wall Mounting the RHI Panel

1. Prior to mounting the panel, the microprocessor
module must be removed from the enclosure.
Complete Step 2 in the previous section before
proceeding.
2. With the microprocessor removed, refer to
28, p. 53 for the location of the mounting holes to
be used for wall mounting.
3. Place the enclosure against the mounting surface
and mark the mounting holes.
N N o o t t e e : : Note: The top of the enclosure is marked with
"TOP."
4. With the enclosure in the correct position, remove
the enclosure and drill the necessary holes in the
surface for the appropriate fasteners, (plastic
anchors, molly bolts, screws, etc.)
5. Remove the necessary knockouts for the wire or
conduit entry before mounting the panel.
6. Place the enclosure back onto the surface and
secure it with the appropriate screws.
7. Follow Step 5 in the previous section to replace the
microprocessor within the enclosure.
Figure
SCXF-SVX01Q-EN