Table of Contents
Advertisement
SETUP MENU
11 SETUP MENU
The Setup Menu provides clock, calibration, plug storage/retrieval, and language settings.
11.1 Time and Date
1. TIME & DATE
2. SYSTEM SETUP
3. TEMPERATURE
CALIBRATION
4. HUMIDITY CALIBRATION
5. EC/PH CALIBRATION
6. SENSOR LOGGING
7. WRITE TO DATA PLUG
8. READ FROM DATA PLUG
Note: In any given menu, you may use arrow and ENTER keys on touch pad to make a selection or press the
corresponding number and ENTER on touch pad as a short cut.
The Time & Date screen allows you to set the current time and date as well as the end of the crop daytime.
To adjust the time and date, place the cursor on the setting you wish to modify, change the numbers using the keypad
and press ENTER to save your changes.
• End Day Time: Select the start time of a new day 00:00 to 23:00. At End Day time:
All the alarms are reset.
All the uncompleted irrigations are reset.
All the valves that are registered in the uncompleted programs table and did not complete the irrigation
are switched from Wait position to Do Not Continue (Move to history).
Cycle days in the PROGRAM table are moved one day ahead.
The daily % change is zeroed (the constant % change stays the same).
Currently active cycle will continue with its current settings until completed.
• Start/End time for VPD Sum – Set the time frame for the VPD Sum counter.
Only during this time frame will the VPD be summed
At End time for VPD Sum, the counter is reset
1. TIME & DATE
2. SYSTEM SETUP
3. TEMPERATURE CALIBRATION
4. HUMIDITY CALIBRATION
5. EC/pPH CALIBRATION
6. SENSOR LOGGING
7. WRITE TO DATA PLUG
8. READ FROM DATA PLUG
9. VPD SENSOR SETUP
SETUP
SETUP
Current Time
Date
End Day Time
Start Time for VPD Sum
End Time for VPD Sum
TIME & DATE
05:45:32
9—Feb --13
014
08:00
12:00
NMC-Junior Pro Installation Manual
Page 73
Advertisement
Table of Contents
