Safety Precautions - Ten-Haaft Oyster V Vision Operator's Manual

1. GENERAL INFORMATION

1.4 Safety precautions

To ensure that your satellite system works properly, it is essential that it is correctly connected to the ignition
of your vehicle (see installation manual).
When correctly installed, the antenna automatically returns to and locks into its parking position when the
ignition is switched on. If the system does not retract at all or cannot completely retract due to a fault, then it
is your responsibility as vehicle operator to check and make sure that the antenna is correctly and completely
retracted before driving off.
Zündung / Klemme 15
muss angeschlossen werden
Zum automatischen Einfahren der Antenne
bei Fahrzeugstart
Ignition switch has to be connected
For automatic retraction of the antenna
at vehicle start
Démarrage doit être connecté
Pour rétracter automatiquement l'antenne
au démarrage du véhicule
Road traffic regulations stipulate that the vehicle operator must verify the vehicle's roadworthiness before
each use. This requires the operator to perform a visual inspection of the external unit to make sure that it is
fully retracted.
Please also note that different legal requirements apply to the operation of electrical and electronic equipment in
different countries. As the user of such equipment, you are responsible for ensuring compliance with the relevant
laws and regulations.
STOP FUNCTION VIA THE CONTROL PANEL AND ISOLATION FROM OPERATING VOLTAGE DURING SERVICE WORK
The Sat button on the control panel stops the motion of the antenna. In stop mode, no DiSEqC™ receiver
commands or control commands are executed.
To cancel stop mode, at the control panel scroll
or press the on/off button
sure that the entire system is isolated from operating voltage.
to menu "Automatic search" and or press the selection key
This causes the antenna to retract. When servicing the antenna system, make
5