SECO-LARM ENFORCER SK-910RAQ Installation Manual

ENFORCER RF R
ECEivERs

Specifications:

SK-910RAQ
Range Up to 500' range
11-24 V AC/DC (16~24 VAC/DC must cut LP4)
Operating Voltage
Memory Capacity
15 transmitter button codes per channel
Current Draw
5mA standby, 50mA LED flashing @
12VDC
Output mode Programmable 4-sec. momentary (default), 1-sec. momentary, toggle (ON/OFF), or validity
Output type 3A Form 'C' relay (NO/NC/C).
Dimensions 3 3 / " x 2 9 / " x 3 / " (80 x 65 x 19 mm)
16 16 4
Frequency 315MHz. (Other frequencies available. Please contact SECO-LARM.)
Transmitter Compatible with all SECO-LARM transmitters

Compatible Transmitters

Fixed-Code: 68 billion codes. CODEBUMP code-hopping: 18 quintillion (1.8 x 10
Pendant Remotes
# of # of
Model Number
Buttons Channels
SK-919TD1S-U
1 1
SK-919TD1S-UP
SK-919TD2A-U
SK-919TD2A-UP 2
3
SK-917T2A
SK-919TP3J-N
3
7
SK-917T3J
SK-919TP4J-N
4
15
SK-917TP4J-N
Hand-Held Remotes
# of # of
Model Number
Buttons Channels
SK-919TP1H-B 1 1
SK-919TP2H-N 2 3
SK-919TP4H-N 4 15
Accessories
SK-9HBC Belt clip holster for hand-held remotes
WARRANTY: These ENFORCER RF receivers are warranted against defects in material and workmanship while used in normal
service for a period of one (1) year from the date of sale to the original customer. Our obligation is limited to the repair or replacement of
any defective part if the unit is returned, transportation pre-paid, to SECO-LARM.
Copyright © 2013 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part,
without the written permission of SECO-LARM.
The SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right to change specifications without further notice.
SECO-LARM ® U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326
SK-910RAVQ SK-910RAV2Q
Up to 500' range
3-13.8 VDC
5mA standby, 15mA LED flashing @ 12VDC
Transistor GND x 1, 5A @ 12VDC Transistor GND x 2, 3A @ 12VDC
) codes
19
Blank or CODEBUMP
Coding
Pre-coded
With SECO-LARM's
Fixed Blank
CODEBUMP, so-called
Fixed Pre-coded
code-grabbers and scan-
Fixed Blank
ners are rendered obsolete
Fixed Pre-coded
because the RF code changes
Code Hopping Pre-coded
every time the transmitter
Fixed Pre-coded
button is pressed. In addition,
Code Hopping Pre-coded
with over 18 quintillion (1.8
Fixed Pre-coded
x 10 ) codes, the chances
19
Code Hopping Pre-coded
of ever repeating a code are
virtually non-existent.
Blank or
Coding SECO-LARM's CODEBUMP
Pre-coded
transmitters and receivers
Fixed
Pre-coded
are perfect for controlling
Fixed
Pre-coded
garage and gate openers,
Fixed
Pre-coded
car and home alarms,
plus much more.
FILE: D\DTP\Manual\Mi-SK-910RAxxQ_051013.indd
® PITSW1
Website: www.seco-larm.com
E-mail: sales@seco-larm.com

Installation Manual

ENFORCER
SK-910RAQ SERIES
Miniature RF
Receivers
Up to 500 ft. range
l
Operate on 11-24VAC/DC
l
Code learning
l
FCC compliant
l
Fixed code or CODEBUMP code-hopping
l
Introduction
These mini RF receivers are compatible with both code hopping and fixed-code transmitters (see page 4 of this manual
for a list of compatible transmitters). They can be used for a variety of applications, such as allowing the same transmitter to
arm/disarm a vehicle alarm and open/close a garage door opener. The receivers come in one- or two-channel versions.
Each channel can learn the codes of up to 15 different transmitter buttons on a first-in, first-out basis.

Installation Notes

1. Mount out of sight in a location where it is not surrounded by metal, and where it is not exposed to the weather or
moisture. Metal will block the RF signal, resulting in a reduced range.
2. For best range, pull the antenna wire as straight and high as possible. If the receiver receives interference from local
RF activity (eg., airport or military base), the antenna wire can be folded. DO NOT CUT THE ANTENNA WIRE.

Models Available

SK-910RAQ ............1-channel mini-receiver, 3A Form "C" relay, 315MHz
SK-910RAVQ .........1-channel mini-receiver, 5A transistor ground output, 315MHz
SK-910RAV2Q .......2-channel mini-receiver, 3A transistor ground outputs, 315MHz
SK-910RA-4Q ........1-channel mini-receiver, 3A Form "C" relay, 433.92MHz
SK-910RAV-4Q ......1-channel mini-receiver, 5A transistor ground output, 433.92MHz
SK-910RAV2-4Q ...2-channel mini-receiver, 3A transistor ground outputs, 433.92MHz
More RF receivers are available (1 to 4 channels). Contact SECO-LARM for details.
Order Part #762-107-3%
SECO-LARM
Page 4
Note: Products with model numbers that end with "Q" or that have a round green"Q"sticker are RoHS compliant.
1
All models work on 11-24VAC/DC, except for the low voltage versions.
1
®
ENFORCER RF R
ECEivERs
®
SK-910RAQ
Shown