Settings For The Basic Operation - Roland HandSonic HPD-15 Owner's Manual

Chapter 5 Settings for the Entire HPD-15

Settings for the Basic Operation

fig.5-04.e
Category Parameter
UTILITY LCD Contrast
Beep Level
MasterTune
Pad Chase
Power ON
Dial Lock
Roll Sync
Seq Sync
68
Adjusting the Contrast of the Display
Increasing the value will darken the display.
Adjusting the Volume of the Operating Sound
When set to "0," no operating sound will be heard.
Tuning the Instruments
This adjusts the pitch of instruments marked with "*T" in the
Instrument List (p. 92) and backing instruments (p. 94).
* 440.0Hz is the standard tuning.
Specifying How a Pad Will be Selected for Editing
OFF: The pad last struck in Play mode will be edited. This is convenient when
you wish to compare the response with other pads. If you hold down
[PATCH SEL] and strike a pad, the pad you struck will be edited.
ON: The pad you strike will be selected for editing each time.
Specifying the Patch Selected at Power-On
RESET: Patch P0101 will always be selected.
LAST: The patch last-selected when the power was turned off will be selected.
Locking Patch Selection From the Dial
If this is turned "ON," turning [PATCH/VALUE] will not change the patch.
This lets you prevent the patch from being accidently changed when you
touch the dial during a performance.
Synchronizing Rolls Between Pads
OFF: The roll will start when you press the pad, and will not synchronize
with other pads.
ON: Rolls of other pads will synchronize to the roll of the first-pressed pad.
Synchronizing the Internal Sequencer with an External MIDI Device
Int: The HPD-15's tempo setting will be used for playback /recording.
When shipped from factory, this setting is selected.
Ext: The HPD-15's sequencer will operate in accordance with tempo data
(MIDI Clock) from the external device.
Remote: The HPD-15 will obey start /pause /stop messages from an external
device, but will playback according to its own tempo setting.
Value
1 – 16
0 – 15
415.3 – 466.2 (Hz)
OFF, ON
RESET, LAST
OFF, ON
OFF, ON
Int, Ext, Remote