NewMar POWER-PAC Installation & Operation Manual

Download this manual

Enlarged version

VI) SPECIFICATIONS

Input:

115/230 VAC + 10%, 50-60 Hz.

Output:

13.8 VDC

20 Amps Surge (10% duty cycle, 10 minutes max.)

5 Amps continuous (100% duty cycle)

Regulation:

1% Line and Load

Ripple:

4 mV RMS (@5 amp continuous duty rating)

Current Limit:

Power supply current limit set @ 110% of continuous

duty rating.

Low Voltage Alarm:

Engages @ 10.6 - 10.9 VDC Output

Terminal Voltage

Low Voltage Disconnect: 10.3 VDC Output Terminal Voltage

Internal Battery(s): Sealed, Lead-Acid, Rechargeable, Deep-Cycle

12 Volt, 7 Amp-Hour

Back-Up Battery Float Voltage: 13.8 VDC

Dimensions (H x W x D): 5.25" x 9" x 10.5"

Weight:

16 Ibs. (with one battery)

22 Ibs. (with two batteries)

POWER-PAC

INSTALLATION / OPERATION

MANUAL

Page 1 VI) SPECIFICATIONS POWER-PAC Input: 115/230 VAC + 10%, 50-60 Hz. Output: 13.8 VDC INSTALLATION / OPERATION 20 Amps Surge (10% duty cycle, 10 minutes max.) 5 Amps continuous (100% duty cycle) MANUAL Regulation: 1% Line and Load Ripple: 4 mV RMS (@5 amp continuous duty rating)
Page 2 Override Button. up with the addition of another internal or external battery. If the Power-Pac is already connected to the radio when AC power fails, engagement of the battery back-up is automatic. However, there may be II) FEATURES occasion to install the Power-Pac when there is no AC power available initially.
Page 3 If you require the Power-Pac to operate at 230 VAC input, take the following steps terminals. If you install a second battery, be sure to mark the box next to the 14 before you apply AC power: amp-hour ratings in the matrix on the bottom of the unit.
Page 4 This light, located directly above the On/Off switch will III) FEATURES ILLUSTRATION illuminate when there is AC available to the Power-Pac and the switch is in the “On” position. It is unrelated to DC output. For this illustration, refer to section IV) A, B, C: 3.