Table of Contents
Advertisement
For details on each parameter, refer to "Realtime Controller / D
Beam Controller Settings (Controller)" (p. 52).
2. Move the cursor to the parameter that you want to set, and
turn the VALUE dial or press [INC]/[DEC] to make the
setting.
3. Press [8 (Close)] to close the D Beam window.
Settings for the D Beam controller are saved independently for
each patch/performance as part of the patch/performance
settings. This lets you create patches/performances that make
effective use of controller settings.
Using Knobs or Buttons to
Modify the Sound (Realtime
Controller)
You can use the REALTIME CONTROL knobs and buttons to
modify the sound in real time.
1. Access the PATCH PLAY screen (p. 31).
The "Realtime Control" area shows the function that is assigned
to each realtime controller knob and button. [
the knobs, and [
]–[
] indicate the buttons.
fig.13-03
The MULTITIMBRE PLAY screen does not have a "Realtime
Control" display.
2. While playing the keyboard to produce sound, operate the
REALTIME CONTROL knobs and buttons.
The sound will change according to the function assigned to
each knob or button.
Modifying the Sound in Real Time
Making Realtime Controller Settings
Realtime Controller Knob Settings
1. Hold down [JUMP] and turn one of the REALTIME CONTROL
knobs.
The Knob window appears.
fig.13-04_50
In this window you can set the following parameters for the
REALTIME CONTROL knobs.
Assign: Specify the function that will be controlled by the
realtime control knob.
If you are using this in Performance mode, a Zone parameter
will be added to the parameters listed above. This parameter
specifies the zone that will be controlled by the realtime control
knob.
For details on each parameter, refer to "Realtime Controller / D
Beam Controller Settings (Controller)" (p. 52).
]–[
] indicate
2. Move the cursor to the parameter that you want to set, and
turn the VALUE dial or press [INC]/[DEC] to set it.
3. Press [8 (Close)] to close the Knob window.
Realtime Controller Button Settings
1. Hold down [JUMP] and press a REALTIME CONTROL
button.
The Switch window appears.
fig.13-05_50
In this window you can set the following parameters for the
realtime control buttons.
Assign: Specify the function that will be controlled by the
realtime control button.
Mode: Specify how the realtime control button will operate.
If you are using this in Performance mode, a Zone parameter
will be added to the parameters listed above. This parameter lets
you specify the zone that will be controlled by the realtime
control button.
For details on each parameter, refer to "Realtime Controller / D
Beam Controller Settings (Controller)" (p. 52).
2. Move the cursor to the parameter that you want to set, and
turn the VALUE dial or press [INC]/[DEC] to make the
setting.
163
Advertisement
Table of Contents
