Advertisement
Quick Links
1.
Introduction ....................................................................................................................................................... 2
2.
Install the Roland Comm Firmware Update Setup ............................................................................................ 2
3.
Firmware Update ............................................................................................................................................... 8
4.
Bluetooth Firmware Update ............................................................................................................................ 13
GO:PIANO88
Firmware Update Manual
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Roland GO PIANO88
Summary of Contents for Roland GO PIANO88
- Page 1 GO:PIANO88 Firmware Update Manual Introduction ............................... 2 Install the Roland Comm Firmware Update Setup .................... 2 Firmware Update ............................... 8 Bluetooth Firmware Update ..........................13...
-
Page 2: Introduction
2. PC to send the updater to the instrument 3. USB Standard Cable 4. Roland Comm Firmware Update Setup V2.9.3 (Please download from Roland official website) 5. GO-88P_V130.DAT file (Please download from Roland official website) 2. Install the Roland Comm Firmware Update 2.1 Preparation... - Page 3 2.3 Click “Yes”, “Next >” to continue.
- Page 5 2.4 Click “Install” to start the installation.
- Page 6 2.5 Click “Next” to install the device driver.
- Page 7 Note: If the device driver is not installed or is not properly installed, please refer to 《GO PIANO88 Driver Installation Instructions (Manually)》, install manually the device driver. 2.6 Click “Finish” to complete the installation.
-
Page 8: Firmware Update
2.7 Installation is finished. You will find the Firmware update icon on the desktop. 3. Firmware Update 3.1 Double click the Roland Comm Firmware update icon on PC desktop. ⚫ The Firmware Update window will pop up. Make sure you get the message below before proceeding. - Page 9 The pictures below show the update progress of a keyboard of GO:PIANO88. ⚫ Click the explorer which is showed by red box in the picture below. ⚫ Open the update file “GO-88P_V130.DAT”. ⚫ Check the product model and software version. ⚫ Now the Roland Comm Firmware Update tool is ready.
- Page 10 3.3 Preparation of GO:PIANO88 ⚫ Connect your instrument to a PC with a standard USB cable. Note: Never connect the PC with more than one instrument for each update. ⚫ Make sure the power supply is reliable for the update, and please don’t execute by battery power. 3.4 Enter the Update Mode ⚫...
- Page 11 ⚫ When update mode, LEDs turn on of the instruments as below picture shows. 3.5 Click “↓Update” to start. Note: Do not disconnect the power supply or turn off the instrument during the update! Note: The progress bar may repeat several times (7 minutes) before the update is finished.
- Page 12 3.6 Finish the update. ⚫ Click “OK” to finish the update if you get the message “update successful”. The update is completed now. Note: If you fail to get the above message, please try again: ⚫ Check the USB connection or try with another USB cable. ⚫...
-
Page 13: Bluetooth Firmware Update
4. Bluetooth Firmware Update 4.1 Preparation ⚫ When online update is finished, disconnect the USB cable. Turn off the power. 4.2 Enter the Update Mode ⚫ Press and hold the keys “#1+#2+#3+#7” ([A0] + [A#0] + [B0] + [D#1]) and turn on the power again. It will enter Bluetooth Module Online Update Mode.
Need help?
Do you have a question about the GO PIANO88 and is the answer not in the manual?
Questions and answers