Specifying The Area Of A Song That Will Repeat (Loop Points); Editing Sequencer Data Over The Specified Range (Track Edit); Basic Operation For Track Editing - Roland Piano Owner's Manual

Specifying the Area of a Song that
will Repeat (Loop Points)
When using Loop Play or Loop Recording, you can use the loop
points you specify here to specify the repeated area, as an alternative
to repeating the specified number of measures.
If the song time signature is different than the pattern time
signature (pattern beat), the loop points will be displayed
differently in the song and pattern.
1. Load the song for which you want to set loop points (p. 136).
2. Access the Song Setup window (p. 137).
3. Use
or to select "Loop," and then press [8 (Select)].
The Loop window appears.
fig.11-09_50
4. Move the cursor to the desired parameter, and turn the
VALUE dial or press [INC]/[DEC] to make the setting.
Repeat
Select the number of repeats (1–99). If you want repetition to
continue until you press [STOP/PLAY], set this to "INFINIT."
Start
Specify the location at which repetition is to begin.
If you press [7 (Set)], the current location of the song will be set
as the starting location.
End
Specify the location at which repetition will end. The location you
specify here will not be included in the repeated area.
If you press [7 (Set)], the current location of the song will be set
as the ending location.
5. If you press [8 (Loop)] to assign a check mark ( ), looping
will be turned on.
Editing Sequencer Data Over
the Specified Range
(Track Edit)
Track Edit lets you edit areas of sequencer data that you specify.

Basic Operation for Track Editing

1. Access the Song Edit screen, and then load the song you
want to edit (p. 136).
If you want to edit the pattern, access the Pattern Edit screen by
selecting "Pattern Edit" from the Menu window.
fig.11-10.e
Pattern number
Pattern name
Measure number
Current location
Turns the RPS function on/off (RPS).
Turns Loop Play and Loop Recording
on/off (LOOP).
Indicates/sets the song's playback tempo.
If you select a song that is stored on disk, a message of "The
Song "****" is not Internal Song. Load anyway for Song Edit?"
will ask you for confirmation. If you want to erase the song from
the internal memory and load the new song, press [7 (OK)]. If
you decide not to erase the song from the internal memory, press
[EXIT].
2. Press [8 (Track Edit)].
The Track Edit window appears.
fig.11-11_50
Editing Songs
Indicates the name of the currently
selected song, the measure location,
the time signature, and the sequencer status.
Measures
containing no
sequencer data
Measures
containing
sequencer data
139