Selecting The Part To Which The Effect Is Added (Effectspart) - Roland KR107 Owner's Manual

fig.d-touchpanel.eps_50
Touch <Execute>.
Touch the points indicated.
NOTE
Do this carefully, because touching a location that's different
from the one indicated for the pointer may make the
displacement even worse. Be sure to touch the pointer
accurately.
When the calibration is finished, touch <Write> to store the
settings.
NOTE
If you don't write them to memory, the calibration settings will
be discarded as soon as the power is switched off.
Returning the Touch Screen Calibration
Settings to the Original Factory Settings
If you touch <Factory Reset> in the above screen, the touch
screen calibration settings revert to the original factory
settings.
Chapter 9 Various Settings
Selecting the Part to Which
the Effect is Added
(EffectsPart)
You may find effects not being applied to certain parts when
different effects are applied to the upper tone, layer tone, and
lower tone. In such instances, you can select which effect is to
have priority.
1.
Press any tone button, and select the tone (p. 23).
2.
Touch <Effect>.
3.
Touch <Part>.
A screen like the one shown below appears.
4.
Touch to select the part to which the effect
is added.
The effect will be applied to the selected part and other
parts to which the same effect has been applied.
Available settings
Upper, Layer 1, Layer 2, Lower 1, Lower 2
151