How To Connect Your Extended Power Cables - Samsung AE090MNYDEH Installation Manual

How to connect your extended power cables

1 Prepare the following tools.
Tools
Spec
Shape
2 As shown in the figure, peel off the shields from the rubber and wire of the power
cable.
– Peel off 20 mm of cable shields from the pre-installed tube.
CAUTION
• For information about the power cable specifications for indoor and outdoor units,
refer to the installation manual.
• After peeling off cable wires from the pre-installed tube, insert a contraction
tube.
3. Insert both sides of core wire of the power cable into the connection sleeve.
▶ Method 1
Push the core wire into the sleeve from both sides.
▶ Method 2
Twist the wire cores together and push it into the sleeve.
4 Using a crimping tool, compress the two points and flip it over and compress another two points in the same location.
– The compression dimension should be 8.0.
– After compressing it, pull both sides of the wire to make sure it is firmly pressed.
Compression
dimension
Crimping pliers Connection sleeve (mm)
MH-14 20xØ6.5(HxOD)
▶ Method 1
Compress it 4 times.
5 mm
Insulation tape Contraction tube (mm)
Width 19mm 70xØ8.0(LxOD)
Power cable
20 20
60
120
180
20
Pre-installed tube for the power cable
Connection sleeve
Connection sleeve
▶ Method 2
Compress it 4 times.
5 mm
20
(Unit: mm)
55
English